Over due entry... rudder pedals
Posted: Thu Jul 13, 2023 8:28 am
I took some time recently to relocate all the network gear in my house and rewire the entire house... so that ate up quite a bit of building time. And I have flat neglected to make an entry when I did get some time in. But I'm back at it now, making good progress and will be making more frequent entries again.
Just in case anyone is interested... here is my new network rack installation.
Now, on with the rudder pedal assembly and install...
Just in case anyone is interested... here is my new network rack installation.
- Ubiquiti network gear
- Dimpling before drilling rivet holes
- On the drill press drilling pilot holes
- 1/2" pipe to ensure alignment of both pedals
- All riveted together
- Ground weld beads down to make floor board sit flat
- Install done and torque seal applied
- Beringer brake cylinders going on