Panel & wiring

This is where I will make periodic entries regarding the build progress of my kit. I will post photos, and discuss work completed or problems encountered.
Post Reply
MikeFairbanks
Site Admin
Posts: 92
Joined: Fri Feb 24, 2023 1:51 pm
Location: Fairbanks, AK

Panel & wiring

Post by MikeFairbanks »

I got my instrument panel and wiring harness from Midwest Panel Builders today... they did beautiful work. I can't wait to start installing it in the airplane.
Attachments
IMG_2654.JPG
IMG_2655.JPG
IMG_2656.JPG
MikeFairbanks
Site Admin
Posts: 92
Joined: Fri Feb 24, 2023 1:51 pm
Location: Fairbanks, AK

Re: Panel & wiring

Post by MikeFairbanks »

I got the panel drilled and mounted, and started on the top braces... the first one was pretty straight forward, but I'm waiting to hear back from MWPB before making the second one...
IMG_2661.JPG
IMG_2662.JPG
IMG_2663.JPG
And then of course, I had to throw the boxes in and sit in it for a bit imagining what it will be like to fly... I like it!
IMG_2664.JPG
MikeFairbanks
Site Admin
Posts: 92
Joined: Fri Feb 24, 2023 1:51 pm
Location: Fairbanks, AK

Re: Panel & wiring

Post by MikeFairbanks »

First partial power up... everything looking good. Still lots of wiring details to work on.
IMG_2679.JPG
MikeFairbanks
Site Admin
Posts: 92
Joined: Fri Feb 24, 2023 1:51 pm
Location: Fairbanks, AK

Re: Panel & wiring

Post by MikeFairbanks »

Working on securing the wiring in place... I made a bracket that goes between rudder pedal adjustment lever brackets, and started adding Adel clamps.
Attachments
IMG_2705.JPG
IMG_2708.JPG
IMG_2709.JPG
IMG_2710.JPG
IMG_2711.JPG
IMG_2712.JPG
MikeFairbanks
Site Admin
Posts: 92
Joined: Fri Feb 24, 2023 1:51 pm
Location: Fairbanks, AK

Re: Panel & wiring

Post by MikeFairbanks »

Remote avionics bay behind the baggage area...
Attachments
IMG_2713.JPG
IMG_2714.JPG
IMG_2715.JPG
MikeFairbanks
Site Admin
Posts: 92
Joined: Fri Feb 24, 2023 1:51 pm
Location: Fairbanks, AK

Re: Panel & wiring

Post by MikeFairbanks »

On my first attempt to power up the GNX 375 didn't come on... a little digging and I found a bent pin... got that straightened out and everything powered up fine.
Attachments
Bent pin on GNX 375 connector
Bent pin on GNX 375 connector
Pin all straightened out
Pin all straightened out
Successful power up!
Successful power up!
Post Reply