More vertical stab work...

[MikeFairbanks]

I finished the stab access flanges, fully installed, bonded and rivetted. I had to notch the front flange to clear the comm antenna I installed in the stab...

Next I started working on the fiberglass stab trailing edge. I got it cut to length, holes for the hinge points and rudder travel stop cut, rib notches messaged to fit right, and finally glued into place.

[MikeFairbanks]

So... after all the work I did to get the vertical stab fairing to fit nicely I realized I had done it wrong and had to remove it and redo it. Here it is after making the necessary changes and gluing back in place.