Autopilot servos
-
MikeFairbanks
- Site Admin
- Posts: 87
- Joined: Fri Feb 24, 2023 1:51 pm
- Location: Fairbanks, AK
Autopilot servos
I got the YD plate mounted the day after Christmas, but just got back out here yesterday to get busy again. I got both the roll and pitch servos mounted yesterday, and finished up the push-pull rods today, got what I could torqued and marked, and installed the over-center stop bracket on the pitch servo today.
- Attachments
-
- Yaw servo and mounting plate installed
-
- Yaw servo cable clamps loosely installed
-
- I'm thinking the pull-pull cables should be on the bottom of the servo arm
-
-
- Roll servo and plate mounted
-
- Roll push-pull rod hooked up
-
- Pitch servo and plate mounted
-
- Yaw servo, different angle of the pull-pull hookup
-
- Pitch push-pull rod hooked up
-
- Pitch rod at servo end
-
- Roll rod won't get torqued until the flaperons are rigged
-
-
- Over-center plate installed